Gallery

Why we wanted to be part of your success :

How to setup and configure shared storage within vSphere Cluster using OpenFiler




Institute View:










Our Lab hardware(each system) configuration :

ESXi patching demo :

Session on RDM and MSCS :


ESXi command line :


VMHBA :

vRealize Automation Training : 


Session on architecture of ESXi :

Mathematics Classes:







Comments

Post a Comment

Popular posts from this blog

Designing and Configuring an Enterprise Cloud Solution

Image
We have already discussed the architecture of a vRealize Automation environment in previous post. Many topics, including the physical, conceptual and logical design have been covered. These design documents helped us to set up a vRealize Automation environment. However, in order to proceed with the configuration of vRealize Automation, we again need to shift our focus towards the design aspects of implementing a vRealize Automation platform. This chapter will help you to understand these fundamental design concepts. In the following, we will focus on the different components as well as on security aspects. For the most part, this chapter deals with describing the building blocks within a vRealize Automation environment. Afterwards, it will end up with discussing a couple of further design aspects. This chapter will only focus on design issues. The implementation itself will be described in the following chapters. 6.1 vRealize Automation Layers Traditionally, one of the key requ...
Read more

"Host IPMI system event log status" alarm in vCenter Server

To resolve this issue, ensure that the NTP settings are correct on the ESXi host, clear the IPMI System Event log file, and reset the sensors.   To clear the IPMI System Event log file and reset the sensors: Open vCenter Server using the vSphere Client. In the vCenter Server Inventory, select the ESXi/ESX host. Click the  Hardware Status  tab. Click  System Event log  under View. Click  Reset Event   Log . The red alert is removed from the System Event log. Click  Reset Sensors  to reset the host sensors. Starting with ESXi 5.1 U2, 5,5 P01 and later, you can use the  localcli  command line to clear the IPMI SEL logs. To clear the IPMI SEL logs in ESXi 5.1 and later: Connect to the ESXi host through SSH.  Run this command: localcli hardware ipmi sel clear If you find an incorrect date and if you are unable to reset the logs: In ESX - Restart the management agents and  sfcbd...
Read more

Virtual machines appear as invalid or orphaned in vCenter Server

Symptoms Virtual Machines show as invalid or orphaned in vCenter Server Virtual Machines show as invalid or orphaned after a VMware High Availability (VMware HA) host failure occurs Virtual Machines show as invalid or orphaned after an ESX host comes out of maintenance mode Virtual Machines show as invalid or orphaned after a failed DRS migration Virtual Machines show as invalid or orphaned after a storage failure Virtual Machines show as invalid or orphaned after the connection is lost between the vCenter Server and the host where the virtual machine resides You see one or more of these errors when trying to start a virtual machine: Could not power VM, no swap file, failed to power on VM. VMControl error -11: No such virtual machine. A general system error occurred. The system returned on error. Communication with the virtual machine may have been interrupted In   C:\ProgramData\VMware\VMware VirtualCenter\Logs\vpxd.log   file, you see entries similar to: [11...
Read more